DO NOT TRY THIS AT HOME : Rotteneggs.com text files and message bases are for INFORMATIONAL PURPOSES ONLY. DO NOT undertake any project based upon any information obtained from this or any other web site.We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
(48 votes) Published: Apr 01, 2005 8:08 p.m. In 2 Favorites Lists Viewed 1039 times
WHAT YOULL NEED:
1 Liter soft drink bottle
Knife or razor
bowl and stem
chewin gum (for seal)
drill with a drill bit a little wider than the stem. (you can use a knife, but the seal may not be good. A proper seal is bst for this design!
Cut the soft drink Bottle in half. put the Bottom end inside the top half. Take the cap and drill a hole in the top. Fit the stem through the cap and seal in place with chewing gum. Screw cap back on to bottle.
HOW IT WORKS:
This bong works on suction not gravity. start by compressing the two halves of the bottle together. Then load the bowl. NOTE: if you load the bowl during the compression stage the pot will fly out!!!! Light the dope and pull the two halves apart. This will cause the bottle to fill. now... remove the cap, put your mouth over the mouth of the bottle and compress (slide) the halves together. This should force a good amount of smoke into your lungs causing you to pass out on the floor!!!!
I do not take any responibility for anything that happens when you try this (But its cool)